Skip to main content 
Description
In-deck lights sit flush in the deck boards themselves, marking edges and pathways from underfoot. They give the low grazing light that makes a deck usable at night without any fixture at eye level.
Specification
Installed into the surface of TimberTech or Azek deck boards. Bronze only, sold in four-packs.
Where to position them
In-deck lights earn their place at edges, along step approaches and around the perimeter of a seating area, where they mark a boundary underfoot. Scattered across open decking they read as decoration rather than lighting.
Before you cut
Each fixture needs a hole cut through the board and cable run beneath, so mark out the full layout and check it against the joists below before drilling. A light positioned directly over a joist cannot be wired without moving it.
Before you order
Decide positions before the boards go down. Retrofitting in-deck lights into a finished surface means lifting boards, which is the one job on this list worth planning around.
Part of our TimberTech and Azek Lighting range. Prefer it installed for you? See outdoor lighting installation.
